1、济南铝板http://www.jngdly.com/阳极氧化膜厚缺乏，处理的办法是检查阳极氧化技术是不是标准，看温度，电压，导电等要素是不是安稳，若有反常，请相应调整标准之，若无反常，可恰当延长氧化时刻，确保膜厚合格。济南铝板染液pH值太高，可用冰醋酸将pH值调至标准值。
Jinan anodic aluminum oxide film thickness deficiency way to deal is to check the anodizing technology is not the standard, see the temperature, voltage, electrical conductivity and other factors is not secure, if unusual, please adjust the appropriate standards, if not unusual, may be appropriate to extend the oxidation time to ensure qualified film thickness. Jinan aluminum dyebath pH is too high, can be used acetic acid and the pH was adjusted to the standard value.

2、济南铝板氧化后工件在水槽中放置时刻太久，发起及时染色，假如这种状况现已发作，可将工件放在阳极氧化槽中或硝酸中和槽中恰当活化处理后再进行染色，作用会很好，选用染料不妥，需选用合适染料。
After placing the workpiece Jinan aluminum oxide in the sink long time, initiate timely staining, if this situation has been attack, the workpiece can be placed in the anodizing bath or nitric acid neutralization tank proper activation treatment after dyeing, the role will be well, the choice of dye wrong, need to choose the right dye.

3、济南铝板染料已分化或霉变，此刻需替换染料，济南铝板氧化温度过低，致使皮膜致密：可恰当进步氧化温度。
Jinan aluminum dye differentiated or mildew, and now need to replace the dye, Jinan aluminum oxidation temperature is too low, resulting in a dense film: the progress of the oxidation temperature may be appropriate.

4、济南铝板http://www.jngdly.com/导电不良，可能阳极铜杆或阴极铅板触摸不良所示批量导电不良，留意清洁阳极铜杆及阴极铅板，确保触摸良好。
Jinan poor conductivity of aluminum, copper rod anode or cathode may touch the bad stereotype bulk conductivity shown poor attention to cleaning the anode and cathode copper rod stereotype, to ensure a good touch.